A Vance company - serving Tomball, TX

FAAC Keypad & Intercom Repair Nationwide

Every visit starts with

Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted

The assessment is free and the quote is the invoice.

Styles & brands we work with

Wrought iron
Wrought iron
Wood & steel frame
Wood & steel frame
Farm & ranch
Farm & ranch
Sliding driveway gates
Sliding driveway gates
LiftMaster operators
LiftMaster operators

Before & after – our own jobs

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

FAAC Keypad & Intercom Repair: The Tomball Owner’s Guide

If your FAAC keypad has stopped taking codes or your intercom crackles when a delivery driver buzzes the house, we stock the repair parts on our trucks and typically complete the swap same-day in Tomball. Installed replacement for a FAAC keypad or intercom module runs between $240 and $410 depending on the series, and that price is written down before we touch a single wire. Most owners discover the failure the same way: the gate still opens from the remote inside the car, but the keypad outside is dead, or the intercom speaker works one day and sounds like a blown-out radio the next.

Call (346) 248-7685

Vance Gate Repair Tomball is an independent service provider, not affiliated with FAAC. But we carry their keypads and intercom boards because FAAC gates are all over Tomball driveways, and we’d rather replace the component than tell you to buy a whole new operator.

Which FAAC Models This Applies To

FAAC keypads and intercom modules divide into two rough families. The first is the hard-wired keypad line: the XKP series and the older DigiKey models, which tie into FAAC control boards like the 455 D, 415, and S418. The second is the phone/intercom entry line tied to FAAC gate systems using a separate intercom board, often paired with a DoorKing or Viking phone entry retrofit on older Tomball properties.

The compatibility gotcha we see most often: a homeowner buys an XKP-100 because it’s cheaper, then finds the original system ran an XKP-640 with a longer cable run. The 100 is fine for runs under 100 feet; beyond that, voltage drop causes intermittent keypad behavior, and the 640 is what’s needed. We identify the exact part on site, but if you can open the keypad housing and photograph the label, we’ll bring the right replacement on the first trip.

On OEM versus aftermarket: for FAAC keypads we use OEM parts. The knockoffs fail at the weather seal inside eighteen months in Tomball’s humidity, and we won’t install a part we’d be back replacing under our 365-Day Done Right Promise. For intercom speaker cones and microphone cartridges, quality aftermarket equivalents are fine and save you $60 to $90.

Signs Your FAAC Keypad & Intercom Repair Is Failing

Professional welding and repair service on a decorative metal gate hinge.
Signs Your FAAC Keypad & Intercom Repair Is Failing
  • Keypad lights up but the gate doesn’t move. The number pad has power, but the data line to the control board is dead, usually a corroded terminal inside the keypad housing after years of Houston-area moisture.
  • Intermittent access; codes work sometimes, fail others. This is the voltage-drop symptom, common on FAAC keypads wired more than 100 feet from the operator or on circuits with degraded wire nuts from the original install.
  • Audio out of the intercom is faint or distorted. The speaker cone has deteriorated, or the output capacitor on the intercom board has drifted. Either way, the fix is a board-level replacement, not a volume adjustment.
  • The intercom buzzes when idle, or clicks when someone speaks. A failing ground connection or a worn microphone cartridge. We trace the exact break before we quote it; you get a photo of what we found.
  • Keypad works, but only for the first two digits, then resets. The membrane contact strip inside the keypad has a dead zone. This is not a reprogramming issue. A new keypad or internal contact pad replacement fixes it.
BeforeBefore
AfterAfter

Replacement Cost & What’s Included

In Tomball, an installed FAAC keypad or intercom component swap runs $240 to $410, parts and labor together. The spread comes from the part itself: a basic XKP keypad runs around $140 to $200 as a part, while an intercom board with new speaker and handset runs higher. Labor is usually one hour, plus a trip charge that we roll into the flat price.

Every price includes removing the old part, wiring the new one with sealed connectors, setting the new code or intercom parameters, and testing the gate through a full open and close cycle. Before work starts, you see the written price and approve it. After the work, you get the photo record: the failed part, the new part installed, the wiring before and after. That’s the Haven Standard, Clause 1 and Clause 4, and it’s not optional. The 365-Day Done Right Promise covers the full repair for one year.

DIY or Call Us?

Technician performing professional gate latch repair and maintenance
DIY or Call Us?

There are two things you can safely check before calling us. First, confirm the keypad has power: does the backlight come on, or is the intercom handset buzzing? Second, check the breaker for the gate operator. If the operator breaker tripped, the keypad goes dark too. Reset it once and see if the problem clears.

Beyond that, we recommend against opening the FAAC housing yourself. These keypads and intercom boards are line-voltage adjacent; the control board carries 24VAC on the low side but the run back to the operator can carry 110V, and a wrong probe touch shorts the board. A $90 eBay keypad becomes a $600 board replacement that way. If the gate still opens from the remote but the keypad is dead, call us at (346) 248-7685. We’ll name the part, name the price, and have it installed before the sun sets.

Get the price in writing before anything starts.A real person answers, day or night.
Call now

FAQs

Call Vance Gate Repair Tomball

Technician using an angle grinder to perform professional metal gate repair
Call Vance Gate Repair Tomball

If your FAAC keypad or intercom is failing, call (346) 248-7685. A live person answers, day or night. We’ll tell you what we stock, what it costs installed, and when we can be at your gate. Adrian Vance has been servicing Tomball gates since before half the neighborhoods off Boudreaux Road were built, and his rule hasn’t changed since day one: name what you found, name what it costs, name what you left behind. That’s a quote in writing, a photo record in your hand, and a part that works for years.

Written by Adrian Vance, Owner, Vance Gate Repair Tomball at Vance Gate Repair Tomball, serving Tomball and nearby areas.

Need Gate Repair help in Tomball? Licensed & insured · 30-60 min response · free estimates
Call (346) 248-7685
Local Service Coverage

Request a Free Estimate in Tomball

Tell us what you need - Vance Gate Repair Tomball responds fast. No obligation.

By requesting your free estimate, you agree to our Privacy Policy and consent to being contacted by phone, text, or email concerning your request, including by the partner businesses that may perform the service.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch